Deneral discussions about supercharging, turbocharging, various engine swaps and part swaps between different years of VW and Audi.
Thread Here: http://forums.generationdub.com/showthread.php?t=21695
Lets say you want to turbo your 2.8L VR6 Y-axis On the y-axis of the map there is the Pressure Ratio. Pressure ratio is defined as follows: ...
I thought I'd share the following info with everyone. (from www.turbochargedpower.com ) :thumbup: TURBO HISTORY TURBOCHARGER THEORY PRINCIPALS...
3.6L vr6 6 speed heres my thred. Ill be covering the myths and facts on this build. I will try to post pics when ever i can. This build will cover...
After months of buying, and waiting for everything needed, I dropped the car off to Jason's today! The HP goal is 475-500awhp, with good power...
I have a 2.0l aba 8v I just swapped from the 1.8l 8v, I have the engine In, And all of the wiring to my knowledge. When I turn the key to the on...
Hey guys, Some of you may know my car, and some may not. Its a mk3 gti with a vortech v2 supercharger. Theres a bit of work done to the engine,...
First post... a buddy of mine told me about gendub, hopefully you guys can help me out or point me in the right direction. I've finished...
?? ^ trying to build the ultimate budget setup, any suggestions?
Hi, I was wondering if anyone can tell me where I can swap my BMW 135i's transmission from automatic to manual in the Toronto area. I would also like...
anyone have any ideas on what kind of problems I may run into?motor mounts,fuel system,etc... any help would be appreciated Thanks
Hey guys I just bought a FMIC off a guy on audizine, and just received it today but to my surprise the packaging he used (little foam pieces) ended...
So I have had thoughts of putting a turbo in my car. I am throwing around a few ideas my first thoughts would be to turbo my current 2.0L 9a motor....
Hey i just wanted to ask if anyone knew how many clicks or rotations i need to adjust for on my new forge splitter valves? Its going on my audi S4...
Hey guys, just wondering if all this seems like a good build ------------------------------------------------------------------------ ENGINE...
hey just wanted to ask what would happen if i just cut the cats out and ran straight pipe to my magnaflow muffler? Engine light would come on but...
Anyone think this oil would be best for a high mileage turbo aba motor? found a site where u can order a 5 gallon drum, shipped, for a total of...
I have a 2.0L and I definitely want to upgrade to either the 1.8t or VR6 in the Spring. I would like to know other peoples opinions as to which...
So yeah, coming back from Euroline, lots of black smoke... spilled oil, and coolant all over the road. Wasnt even boosting, just driving normally. ...
ordered head gasket spacer kit from kinetic motorsport, arp head studs, c2 low compression software i miss my car already and it has only been in...
so i was trying to get out the LAST BOLT to get my charger off and it's right striped the 6mm didn't fit( was stiped by the goof i bought it off of...
I'll use this as my hello introduction as well~ My name is Jason, and as you can see by my post count, I'm a new poster - although I've been lurking...
Hey so my S4 is now on the road and well I've been experiencing somesort of crackling noise happening once i giv the car a bit of gas. If i go full...
hi guys, new to the site, so not sure werei this needs to be, but recently dont 20vt conversion on my corrado 16v and for sum reason the relay for my...
hey guys new to the forum my question is for anyone that has swaped a mk3 1.8(acc) to a 2l(aba) i really disslike my mk3 1.8 its painfully slow...
So, i took it upon myself today to try and install the turbo timer i bought on my mk3 golf. hooked up the 12v constant to the 12v constant in the...
I need to know if anyone has a spare oil inlet fitting for a Garrett BB turbo with built in restrictor...... or knows where to buy one... other than...
hey so i've been experiencing pretty big amounts of water flying out of my exhaust. its happened many times now. its not just a drip. its a spray out...
Okay... So as some of you may know, I just tend to have ideas of what parts I have laying around that just might wind up bolting together. And being...
i was watching some videos on youtube, this guy has a jetta 2.0 aba with a stage 2 kinetic kit - which, he claims, only has a head gasket spacer from...
Direct bolt up? Or major modifications required, I have access to the porsche, and am selling my P5 to get a VW. And i want this certain...
I have a 2003 golf 2.0 auto and i have a 2000 gti with the vr6 and 5 speed but its a write off, is it possible to swap the vr6 and the 5 speed into...
tried searching but no luck, maybe someone has asked it and if they have could ya point me to the right thread, is it possible or even worth while...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
